To Next Page

To Previous Page

Select the input mode

Introduction

You can use the ‘Input mode’ setting to specify how a job will be sorted: the ‘Single sheet’ option

treats each sheet as a separate job. “Multiple sheets” produces the specified number of copies

for each sheet in a job and then continues with the next sheet. Graphically that would look

something like this:

1 1 1 2 2 2 3 3 3 4 4 4

You can use the ‘Input mode’ setting to specify how a job will be sorted: the ‘Single sheet’ option

treats each sheet as a separate job. “Multiple sheets” produces the specified number of copies

for each sheet in a job and then continues with the next sheet. Graphically this looks as follows:

1 1 1 2 2 2 3 3 3 4 4 4

[79] The principle of ‘Multiple sheets’

‘Set’ produces one copy for each sheet in a set and then continues with the next copy of the

entire set, as follows:

1 2 3 1 2 3 1 2 3 1 2 3

[80] The principle of set copy

The current input mode can be closed by pressing the Stop key.

The currently selected input mode is indicated by the ‘o’ symbol.

Procedure

Select a template.

Select the “Feeding” card in the “Original” section.

Select the desired media with the “Input mode” function key.

[81] Select the input mode

Select the input mode

234

Chapter 6 - Use the Océ TDS600 scanner for copy and scan-to-file jobs

Oce PlotWave 750 User Manual

Other manuals for Oce PlotWave 750