Define settings for the next original
Introduction
You can define the settings for each original you want to copy. When ‘Automatic feed’ is enabled,
you should bear in mind that the original is automatically pulled into the scanner. If you want to
be absolutely sure about the settings that belong to an original, insert an original when the
settings are correct.
NOTE
To increase your versatility at the scanner input side, you can ask your key operator to turn off
automatic feed. When using the scanner with automatic feed off, you must press the start key for
each new original to be scanned. This offers you the possibility to change the settings for the
next original, even if you already put the original in place on the scanner feed table.
Procedure
1.
Select the “Preference” section.
2.
Press the ‘Rewind original’ function key to make your selection:
• If ‘Automatic feed’ is off, press the start key.
• If ‘Automatic feed’ is on, the original is fed automatically.
Define settings for the next original
238
Chapter 6 - Use the Océ TDS600 scanner for copy and scan-to-file jobs
To Next Page
Loading...
Need help?
General