Clear an original jam on the Océ TDS600 scanner
Introduction
When an original jam occurs on the scanner, the message “Original jam” appears on the scanner
display. You must remove the original from the scanner.
If an original jam occurs often:
• Check if you use the correct type of original.
• Check if you insert the original along the guide.
• Check if the original is damaged before you insert it.
Procedure
1.
Open the top cover of the scanner; see the illustration below.
[155] Open the top cover of the scanner
2.
Remove the original.
3.
Lift the top cover of the scanner to release the lock of the hinge and close the cover; see the
illustration below.
[156] Close the top cover of the scanner
4.
Make the original smooth and feed the original.
NOTE
When you are working with poor-quality or valuable originals, you are advised to disable the
rewind function to avoid the risk of jams during rewind.
Clear an original jam on the Océ TDS600 scanner
338
Chapter 8 - Maintain and troubleshoot the Océ PlotWave 750 system
To Next Page
Loading...
