Oce PlotWave 750 - How to Set the Tray Selection Method

How to set the tray selection method
Introduction
If you want to define the tray selection method of the Océ Double Decker Pro, you can do this in
Océ Express WebTools. You can set one of the following tray selection settings in the
[Preferences] at the Océ Express WebTools.
• [Tray selection method]
• [Tray selection on job type]
• [Tray selection switch between sets: minimum number of sheets]
• [Tray selection based on media size]
Procedure
1.
To define the tray settings: Manually switch the tray selection lever on the Océ Double Decker Pro
to the middle position.
2.
Open Océ Express WebTools on the controller or any other workstation and log in as [Key
operator] or [Power user].
3.
Open the [Preferences] - [System settings] tab and go to the [Océ Double Decker Pro: Tray
selection].
4.
Click “Edit” in the settings group bar or click on the value of a single setting.
5.
Enter your preferred settings.
6.
Click “OK” to confirm you entries or “Cancel” to reject your entries.
Result
The printer's output is delivered in the preferred selection and on the selected tray.
How to set the tray selection method
300
Chapter 7 - The finishing options