Image card settings
Scale
Introduction
The “Scale” option allows you to scale while scanning to a file. When you set “File mode” to
“On” then the automatic “Scale” setting will result in “1:1”.
You can change this default setting into one of the following three settings.
• Custom
• 1.1
• Scale table
• Automatic
Custom
This option lets you specify a scale value. You can enter a range from 25% through 400%. This
value also shows the scale value when the option “Automatic” is chosen.
1.1
With this option selected, scan-to-file will result in an image that is exactly the same size as the
original. “Scale” displays 100%.
Scale table
This option lets you select a predefined reduction or an enlargement conversion.
Automatic
Selecting “Automatic” always results in a 1:1 scan-to-file.
Image card settings
256
Chapter 6 - Use the Océ TDS600 scanner for copy and scan-to-file jobs
To Next Page
Loading...
