Oce PlotWave 750 - Empty the Waste Box

Empty the waste box
Introduction
If a reinforcement unit is installed, the protective sheet from the reinforcement tape is stored in a
waste box. For each roll of tape, you must empty the box twice.
NOTE
You can empty the waste box while the printer is running.
Procedure
1.
Open the waste box.
• First pull the waste box to the left-hand side.
• Next pull the waste box to the front'.
[185] Opening the waste box
2.
Empty the box.
3.
Close the waste box.
• First push the waste box forward.
• Next push the waste box to the right-hand side.
[186] Closing the waste box
Empty the waste box
354
Chapter 8 - Maintain and troubleshoot the Océ PlotWave 750 system