Configure the pen settings
Introduction
Normally the pen settings are defined in the application that is used to create a drawing. If the
pen settings are not defined in the application, the default pen settings configured in the Océ
Express WebTools are used.
NOTE
Before you can edit a setting or a settings group, you must be logged on as a key operator or
power user.
Illustration
Procedure
1.
Click [Configuration] - [Pens].
2.
Click on the value of the pen number that you want to change.
The pen settings window appears where you can configure the color, width and pattern for this
pen.
3.
Click [Ok] to confirm your entries or [Cancel] to reject your entries.
Configure the pen settings
100
Chapter 3 - Define your workflow with Océ Express WebTools
To Next Page
Loading...
Need help?
General