Stop a copy job
Introduction
You can stop a copy job with the red Stop key on the scanner operator panel.
Procedure
1.
Press the red Stop key.
NOTE
This will not affect a set job.
Result
When you press the red Stop key while the scanner scans, the scan process stops. The scanner
rewinds the original and the copy job is canceled.
When you press the red Stop key while the scanner rewinds, the rewind process continues. The
copy job is canceled.
Stop a copy job
Chapter 5 - Use the Océ TC4 scanner for copy and scan-to-file jobs
187
To Next Page
Loading...
