Oce PlotWave 750 - Prepare the Tape Roll for Operation

Prepare the tape roll for operation
Procedure
1.
Remove the protection sheet from the tape.
[180] Peeling off the protection sheet
2.
Guide the protection sheet back between the upper and lower knife.
[181] Leading the protection sheet between upper and lower knife
3.
Lift the guide and move the protection sheet between the protection sheet rollers. Pull the
protection sheet tight.
[182] Leading the protection sheet between the rollers
4.
Insert the strip of the tape into the closed section of the slide.
Prepare the tape roll for operation
352
Chapter 8 - Maintain and troubleshoot the Océ PlotWave 750 system