Define the media series
Introduction
You must indicate in the Océ Express WebTools the media series that you use on your system.
NOTE
Before you can edit a setting or a settings group, you must be logged on as a key operator or
power user.
Procedure
1.
Navigate to [Preferences] - [System settings] - [Regional settings].
2.
Click the value for [Media series] to access the edit window and select the correct media series.
For standard formats listed below, the shortest dimension is the supported roll width in the
media series.
If you want to select a new media series in your submission tool, only the sizes in the defined
media series are available.
Setting Group / Values
[Media series] [DIN: A0, A1, A2, A3, A4, E+ (36 inch), ISO B1, ISO B2]
[DIN carto: A0, A1, A2, A3, A4, E+ (36 inch), 500 mm, 700 mm]
[ANSI small: E, D, C, B, A, E+ (36 inch), 30 inch]
[ANSI mixed: E, D, C, B, A, E+, D+, C+, B+, A+, 30 inch]
3.
Click [Ok] to confirm your entries or [Cancel] to reject your entries.
Define the media series
98
Chapter 3 - Define your workflow with Océ Express WebTools
To Next Page
Loading...
Need help?
General