Preference section
When the job templates are enabled, the ʻPreference’ section allows you to do the following.
• Select the start screen of the scanner operator panel.
Use the ʻstart screen’ function key to select the ʻCustom card’ section or the ‘Templates’
section.
Press the ‘Preference’ section key again to activate the selection.
• Select the original feeding mechanism.
Use the [Automatic feed] function key to make the selection:
- On: Automatic feeding is turned on.
- Off: Automatic feeding is turned off.
Press the ʻPreference’ section key again to activate the selection.
• Select the original delivery option.
Use the [Rewind original] function key to make the selection:
- On: After the scan, the original is transported back to the original feed table.
- Off: The original is fed out to the top of the scanner.
Press the ʻPreference’ section key again to activate the selection.
• Select the default language for the operator panel.
Use the [Language] function key to select the language.
Press the ʻPreference’ section key again to activate the selection.
[68] The Preference section
Preference section
Chapter 6 - Use the Océ TDS600 scanner for copy and scan-to-file jobs
225
To Next Page
Loading...
Need help?
General