Perform basic copy jobs
A number of basic tasks are performed in the Océ TDS600 scanner.
These include:
• Make copies
Make copies
on page 231
• Select the required media
Select the required media
on page 233
• Select the input mode
Select the input mode
on page 234
• Specify the zoom factor
Select the zoom factor
on page 235
• Select the exposure
Select the exposure
on page 236
• Background compensation
Background compensation
on page 237
• Deliver originals after scanning
Deliver originals after scan jobs
on page 239
• Define settings for the next original
Define settings for the next original
on page 238
• Account logging:
Account Logic
on page 241
• Using the manual feed for copying
Use the manual feed for copy jobs
on page 240
• Define delivery of copies
Define the delivery of folded copies
on page 242
• Job interrupt
Interrupt a job
on page 243
• Stop a job
Stop a job
on page 244
• Copy stamping
Stamping
on page 245
Make copies
Procedure
1.
Place your original face-down, right aligned along the original guide. Keep the legend at your
right hand side.
NOTE
When you feed the original, keep it in place until it is transported (about 1 cm (0.4")) into the
machine.
[76] Insert the original
2.
Select a specific template.
3.
Press the green Start key to start the copy or scan to file job.
Your original is fed into the scanner. The printer starts.
Perform basic copy jobs
Chapter 6 - Use the Océ TDS600 scanner for copy and scan-to-file jobs
231
To Next Page
Loading...
Need help?
General