Configure the system for copy and scan
Configure the system for copy and scan with the Océ TC4 scanner
Set the preferences for copy and scan-to-file
Océ TC4 scanner: Define the default output quality for copy and scan-to-file
jobs
Introduction
The Océ Express WebTools offers settings to optimize the default output quality for copy and
scan-to-file jobs made with the Océ TC4 scanner. You can define a default output quality for each
template.
You can find these settings in the [Preferences] - Copy Template 1 to 5 or Scan Template 1 to 5
tabs.
NOTE
Before you can edit a setting or a settings group, you must be logged on as a key operator or
power user.
[Original type]
The quality of the printed output is optimized based on the type of the original that is copied or
scanned.
Setting location: Copy Template 1 to 5 or Scan Template 1 to 5.
Values Description
[Line/text] [Line/text] is default value.
This value is advised for line drawings and design drawings.
Lines and text are optimized, a light background is compensated.
[Artwork] [Artwork] is the recommended value for 3D type originals and sketches
with colored areas. It is available for scan to file in color only.
[Photo] [Photo] is recommended for low end display graphics originals (photo,
poster)
[Gray/lines] [Gray/lines] is the advised value for originals that contain many gray-
scales and lines.
[Dark original] [Dark original] is the advised value for originals with a dark back-
ground.
The output is optimized especially for dark transparent originals. The
system compensates for the dark background and the actual informa-
tion on the original is optimized.
[Blueprint] [Blueprint] is the advised value for blueprints.
The information on the original is inverted. White lines will be black,
the blue background will be white.
4
Configure the system for copy and scan
120
Chapter 3 - Define your workflow with Océ Express WebTools
To Next Page
Loading...
Need help?
General