Make a scan-to-file job
Basic scan-to-file jobs on the Océ TC4 scanner
Introduction to scan-to-file jobs
Introduction
A basic scan-to-file job takes three steps. Feed the original, select [Scan] and press the start key.
Every other type of scan-to-file job, where you change the scan-to-file settings, is called an
extended scan-to-file job. An extended scan-to-file job takes one additional step. Define the scan-
to-file job settings on the scanner operator panel.
When you select [Scan], the scanner operator panel shows five scan-to-file job templates.
These templates have been defined on the system controller (Océ Express WebTools, in the
[Templates] tab).
The scan-to-file job templates provide access to the different settings per scan-to-file job
template. When you select a scan-to-file job template, the scanner operator panel shows the top 5
settings of the selected scan-to-file job template. The top 5 settings are the most often used
settings.You can use the scroll wheel to see the other settings.
Illustration
[64] The scan-to-file job templates
Steps in a basic scan-to-file job
Procedure
1.
Feed the original.
2.
Select [Scan]
3.
Press the green start key.
Result
You get a digital file of your original.
Make a scan-to-file job
206
Chapter 5 - Use the Océ TC4 scanner for copy and scan-to-file jobs
To Next Page
Loading...
