Oce PlotWave 750 - Specify the Number of Overwrite Passes

Specify the number of overwrite passes
Introduction
The e-shredding function allows you to erase jobs from the system. This prevents unauthorized
people from accessing the jobs. You can manually enter the required number of overwrite
passes. Therefore, the setting [E-shredding algorithm] must be set to [Custom]. The more passes
you define, the more reliable the erasing of jobs is. However, more passes take more time. You
can enter any number from 1 to 35. The factory default is 3.
Before you begin
Make sure that [Custom] is selected as the e-shredding algorithm.
Procedure
1.
Go to [Configuration] - [Connectivity] - [E-shredding] - [E-shredding custom number of passes].
2.
Click .
3.
Enter the required number of overwrite passes.
Specify the number of overwrite passes
Chapter 3 - Define your workflow with Océ Express WebTools
91