Select the zoom factor
Introduction
You can use the ‘Zoom’ setting to select a zoom factor.
Procedure
1.
Select a template.
2.
Select the ‘Image’ card in the ‘Print’ section.
3.
Select Automatic, Zoom table, 1:1, or set the zoom factor on the display of the operator panel.
• Automatic zoom selection: the system automatically calculates the zoom ratio based on the
original size and the output media size
• Zoom table: Use the zoom table as defined in the Océ Express WebTools.
• 1:1: Results in an image that is exactly the same size as the original.
• Set the zoom factor on the operator panel display: Use the arrow keys on the right of the
display. If you press one of the vertical keys, the zoom factor will increase or decrease in
increments of 0.1%. If you press one of the horizontal keys, the zoom factor will increase or
decrease at the increments predefined in the Océ Express WebTools by the key operator.
Use the numeric keys at the bottom of the operator panel. You can specify the exact zoom
factor in 0.1% increments.
For example, if you want to specify a zoom factor of 25.4%, you enter 254. If you want to
specify a zoom factor of 254%, you enter 2540.
[82] Select the zoom factor
Select the zoom factor
Chapter 6 - Use the Océ TDS600 scanner for copy and scan-to-file jobs
235
To Next Page
Loading...
Need help?
General