Panasonic FP7 Series Command Reference Manual

2) When the timer execution condition changes from OFF to ON (i.e., rises), the timer set value
is transferred from the set value area "TS" to the elapsed value area "TE" with the same
number. (This is also true when the operation mode is switched to RUN while the execution
condition is ON.)
3) For each scan, the value in the elapsed value area "TE" decrements if the execution
condition is ON.
4) When the value in the elapsed value area "TE" becomes 0, the timer contact "T" with the
same number turns ON.
3.17 TM (Timer)
3-38 WUME-FP7CPUPGR-12

Panasonic FP7 Series Specifications

General

Brand	Panasonic
Model	FP7 Series
Category	Controller
Language	English