Panasonic FP7 Series Command Reference Manual

● It is prohibited to specify the same keyword redundantly. An error is caused in the case of
redundant specification.
Setting
item
Settings
S1
FTP server
number
(Essential)
Specify FTP servers. Specify the following keywords.
SV0: Server 0, SV1: Server 1, SV2: Server 2, SV3: Server 3
IP address or
host name of
FTP server
(Essential)
Specify IP address or host name. For an IP address, specify the keyword "IPv4="
or "IPv6=" at the beginning. For a host name, specify "HOST=".
● For IPv4: IPv4 = 111.122.133.144
● For IPv6: IPv6=1111:122:2:1555:0:0:1888
* For details of the range of IPv4 addresses that can be specified, refer to
"19.10 Ethernet Function: IP Addresses""IP address setting specifications".
● For a host name: HOST=FTP.pidsx.com
Port No.
(Can be
omitted)
Specify port number.
Port No. Range: 1 to 65535
PORT=: Port number (Default: 21)
Open method
(Can be
omitted)
Specify open method.
Active=act/Passive=pasv
OPEN=: Open method (Default = act)
SSL3/TLS1
authentication
(can be
omitted)
Specify whether or not to use SSL3/TLS1 authentication.
SSL: Use SSL3/TLS1 NON: Not use
(Note 1) Input an FTP server number, the IP address or host name of an FTP server, a port number, an open
method, and the SSL3/TLS1 authentication setting separated by a comma ",".
(Note 2) Both upper and lower cases can be used for specifying keywords.
(Note 3) Specify the parameters for specifying servers in the order of the above table.
Setting example
Exam
ple 1
S1 "SV0,IPv4=192.255.2.10,PORT=21,OPEN=act,SSL"
Settings
FTP server number: 0, IP address: 192.255.2.10, Port number: 21, Open method: Active, SSL3/
TLS1 authentication: Use
Exam
ple 2
S1 "SV1,IPv6=1111:1222:1555:0:0:1888,SSL"
Settings
FTP server number: 1, IP address: 1111:1222:1555:0:0:1888, Port number: Omitted (Default: 21),
Open method: Omitted (Default: Active), SSL3/TLS1 authentication: Use
Exam
ple 3
S1 "SV2,HOST=FTP.pidsx.com,PORT=28,OPEN=pasv,NON"
Settings
FTP server number: 2, Host name: FTP.pidsx.com, Port number: 28, Open method: Passive,
SSL3/TLS1 authentication: Not use
■
Operand [S2] setting
● Specify the starting address of the device area that stores the string data that indicates
parameters, or a character constant.
● A part of parameters can be omitted. The settings are not changed when parameters are
omitted partially.
17.11 FTPcSV (FTP Client Connected Server Setting)
17-54 WUME-FP7CPUPGR-12

Panasonic FP7 Series Specifications

General

Brand	Panasonic
Model	FP7 Series
Category	Controller
Language	English