Name Transfer enabled Transfer disabled Transfer canceled
ETSTAT [D] bit15 Transfer disable relay OFF ON Not change
(Note 1) The states of control relays can be checked by using the ETSTAT instruction to read and store the
state in any operation memory.
■
Flag operations
Name Description
SR7
SR8
(ER)
To be set when an item other than "IDx" or "LOGx" or "ALL" is specified for the control target (S1).
(x: 0 to 15)
To be set when an unset transfer setting is specified.
To be set when an unset logging/trace transfer setting is specified.
To be set when an item other than "ENABLE", "DISABLE" or "CANCEL" is specified for the control
content (S2).
To be set when the slot number [S1] specified with UNITSEL is not 100 (built-in ET-LAN).
Set when executed in an interrupt program.
Set when the number of characters for operand specifying character constant exceeds 256.
To be set when a file transfer that has not been specified with the transfer setting instruction or the
tool software is specified.
To be set when a logging/trace transfer setting that has not been specified with the logging/trace
transfer setting instruction or the tool software is specified.
CY
(SR9)
To be set when executed during the initialization of Ethernet. The detail code set in SD29 is "11:
Ethernet initialization active".
(Note 1) For details of the error codes stored in the system data SD29, refer to "20.2 List of System Data
Registers".
17.15 FTPcCTL (FTP Client Transfer Control)
17-80 WUME-FP7CPUPGR-12
To Next Page
Loading...
Need help?
General
