Renault Duster 2007 - Airbag Computer: Removal - Refitting

88C-4
AIR BAG AND PRETENSIONERS
Airbag computer: Removal - Refitting
88C
REMOVAL
I - REMOVAL PREPARATION OPERATION
a
a Lock the airbag computer (see Fault finding - Re-
placement of components) (88C, Airbags and pre-
tensioners).
a Switch off the ignition.
a Disconnect the battery (see 80A, Battery, Battery:
Removal - Refitting, page 80A-2) .
a Remove the centre console (see Centre console:
Removal - Refitting) (57A, Interior equipment).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Disconnect the connector (1) .
a Remove:
- the three airbag computer bolts (2) ,
- the airbag computer.
REFITTING
I - REFITTING OPERATION
a Refit:
- the airbag computer,
- the three airbag computer bolts.
a Torque tighten the airbag computer bolts (8 N.m).
a Connect the connector.
II - FINAL OPERATION
a Refit the centre console (see Centre console: Re-
moval - Refitting) (57A, Interior equipment).
a Connect the battery (see 80A, Battery, Battery: Re-
moval - Refitting, page 80A-2) .
Equipment required
Diagnostic tool
Tightening torquesm
airbag computer bolts 8 N.m
IMPORTANT
Consult the safety and cleanliness advice and oper-
ation recommendations before carrying out any
repair (see 88C, Air bag and Pretensioners, Air-
bag and pretensioners: Precautions for the
repair, page 88C-3) .
IMPORTANT
To avoid any risk of triggering when working on
or near a pyrotechnic component (airbags or pre-
tensioners), lock the airbag computer using the
diagnostic tool.
When this function is activated, all the trigger
lines are inhibited and the airbag warning light on
the instrument panel lights up continuously (igni-
tion on).
107830