13C-2
PREHEATING
Heater plugs: Removal - Refitting
K9K
13C
REMOVAL
I - REMOVAL PREPARATION STAGE
a Remove the front engine cover.
II - REMOVAL OPERATION
a Disconnect the connector from each heater plug.
a Clean around the outside of the heater plugs with a
compressed air nozzle to prevent any impurities
from entering the cylinders.
Equipment required
compressed air nozzle
hinged wrench for heater plug
Tightening torquesm
heater plugs 15 N.m
109466
15762
IMPORTANT
Wear goggles with side protectors for this opera-
tion.
Note:
If the heater plugs jam, use the heater plug
removal tool (see ) (Technical Note 5197A, 06A,
Tools).
To Next Page
Loading...
