86A-3
RADIO
Radio: Removal - Refitting
RADIO NO. 01 or RADIO NO. 02
86A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Switch off the ignition.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Remove the radio (1) using the two.
a
Mark the routing of the wiring behind the radio.
a Disconnect the connectors.
REFITTING
I - REFITTING PREPARATION OPERATION
a
II - REFITTING OPERATION FOR PART
CONCERNED
a Connect the various connectors.
a Fit the wiring in the position marked during removal.
a Refit the radio in its housing.
119085
WARNING
To ensure correct operation:
-do not pinch the aerial cable,
-do not bend the aerial cable,
-do not force the aerial cable when refitting.
WARNING
To prevent any risk of noise, premature wear,
short circuits, etc. after the refitting operation,
mark the wiring routing and how to connect the
connectors.
Note:
Ensure that the ignition is switched off.
To Next Page
Loading...
