Renault Duster 2007 - Bulkhead Seal: Removal - Refitting

36A-10
STEERING ASSEMBLY
Bulkhead seal: Removal - Refitting
36A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
-the front wheels (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, page 35A-1) ,
-the engine undertray.
a Remove the steering box (see Steering box: Re-
moval - Refitting) .
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Unclip the bulkhead seal at (1) using a flat-blade
screwdriver.
a Remove the bulkhead seal (2) .
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Fit the bulkhead seal in its original position.
a Clip the bulkhead seal onto the steering box.
II - FINAL OPERATION
a Refit the steering box (see Steering box: Removal
- Refitting) .
a Refit:
- the engine undertray,
- the front wheels (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, page 35A-1) .
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and opera-
tion recommendations before carrying out any
repair (see 36A, Steering assembly, Steering:
Precautions for the repair, page 36A-2) .
108823