Renault Duster 2007 - Rigid Brake Pipe: Removal - Refitting

33A-10
REAR AXLE COMPONENTS
Rigid brake pipe: Removal - Refitting
33A
The pipes have a rigid and a flexible section.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Fit the pedal press to the brake pedal to limit the
amount of brake fluid running out.
II - REMOVAL OPERATION
1 -Rear left-hand rigid brake pipe
a Unscrew:
- the rigid brake pipe union on the rear axle (1) ,
- the rigid brake pipe union on the rear brake cylinder
(2) .
a Unclip the rear axle rigid brake pipe.
a Remove the rear left-hand rigid brake pipe.
2 - Rear right-hand rigid brake pipe
a Unscrew:
- the rigid brake pipe union on the rear axle brake
hose (3) ,
- the rigid brake pipe union on the rear brake cylinder
(4) .
a Unclip the rear axle rigid brake pipe.
a Remove the rear right-hand rigid brake pipe.
Equipment required
pedal press
Tightening torquesm
rigid brake pipe unions
on the brake cylinders
14 N.m
rigid brake pipe unions
on the rear brake hoses
14 N.m
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and opera-
tion recommendations before carrying out any
repair (see 33A, Rear axle components, Rear
axle components: Precautions for the repair,
page 33A-1) .
WARNING
Prepare for the flow of fluid, and protect the sur-
rounding components.
WARNING
To avoid damaging the wheel speed sensor cable:
- Do not tension the cable,
- Do not twist the cable,
-Check that there is no contact with the surround-
ing components,
- Do not use tools that may damage the cable.
108927
108928