80D-12
AFTER REPAIR
Carry out another fault finding check on the system.
Deal with any other faults.
Clear the stored faults.
V1
MR-453-X79-80D000$080.mif
80D
UCH
Vdiag No.: 09
ET083
LEFT-HAND INDICATOR REQUEST
STATUS DEFINITION
PRESENT when the left-hand indicator is switched on.
ABSENT if there is no request for the left-hand indicator.
NOTES
There must be no present or stored faults.
Switch on the ignition.
Activate the left-hand indicator lights control using the lighting stalk.
The status should be PRESENT.
Special note:
Use the Wiring Diagrams Technical Note for DUSTER.
Check the connection and condition of the indicator lighting stalk connector, component code 209 and the UCH
connector, component code 645.
If the connectors are faulty and if there is a repair procedure (see Technical Note 6015A (Renault) or Technical
Note 9804A (Dacia), Electrical wiring repair, Wiring: Precautions for repair), repair the connector, otherwise
replace the wiring.
Check for earth on connection MAM of component 209.
If the connection is faulty and if there is a repair procedure (see Technical Note 6015A (Renault) or Technical
Note 9804A (Dacia), Electrical wiring repair, Wiring: Precautions for repair), repair the wiring, otherwise
replace it.
UCH_V09_ET083
LIGHTING
Fault finding – Interpretation of statuses
To Next Page
Loading...
