Renault Duster 2007 - Front Side Seat Belt: Removal - Refitting

88C-18
AIR BAG AND PRETENSIONERS
Front side seat belt: Removal - Refitting
88C
REMOVAL
I - REMOVAL PREPARATION OPERATION
a
a Lock the airbag computer using the Diagnostic tool
(see Fault finding - Replacement of components)
(88C, Airbags and pretensioners).
a Switch off the ignition.
a Disconnect the battery (see 80A, Battery, Battery:
Removal - Refitting, page 80A-2) .
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Remove:
- the cover of the seat belt lower bolt,
- the seat belt lower bolt (1) .
Equipment required
Diagnostic tool
Tightening torquesm
bolts of the height
adjustment mechanism
21 N.m
inertia reel bolt 21 N.m
bolt of the seat belt
return mechanism
21 N.m
bolt of the seat belt
lower mounting
21 N.m
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and opera-
tion recommendations before carrying out any
repair (see 88C, Air bag and Pretensioners, Air-
bag and pretensioners: Precautions for the
repair, page 88C-3) .
IMPORTANT
Never handle the pyrotechnic systems (pretension-
ers or airbags) near to a source of heat or naked
flame - they may be triggered.
IMPORTANT
To eliminate the risk of any accident, do not reuse
pyrotechnic components.
It is essential to destroy pretensioners or airbags
before scrapping a vehicle or a part only (see Air-
bags and pretensioners: Recycling - Destruc-
tion) .
Note:
The seat belt must be handled by the inertia reel
mechanism (risk of damaging the strap).
WITH FRONT PRETENSIONER
IMPORTANT
To avoid any risk of triggering when working on
or near a pyrotechnic component (airbags or pre-
tensioners), lock the airbag computer using the
diagnostic tool.
When this function is activated, all the trigger
lines are inhibited and the airbag warning light on
the instrument panel lights up continuously (igni-
tion on).
108517