82D-13
V1
MR-453-X79-82D000$050.mif
82D
UCH
Vdiag No.: 09
CONFIGURATION
New parts are not coded. Once fitted on the vehicle, they must be programmed with a code to become operational.
To perform this procedure, it is essential that some parts on the vehicle are already correctly coded (with the vehicle
code).
Refer to the allocation table.
ALLOCATION TABLE
Blank*: The key allocated to a vehicle must be blank or already programmed to this vehicle.
A new UCH is not coded. You must therefore program a code into a new UCH fitted to a vehicle to make the UCH
operational.
To perform this procedure, at least one of the vehicle's old keys and the repair code are required and the injection
computer must be correctly coded (refer to the allocation table).
AFTER-SALES
OPERATION
STATE OF COMPONENTS
REPAIR CODE
NEEDED
UCH Key Injection computer
Programming
thePassenger
Compartment Central
Unit (UCH)
Blank Coded Coded YES
Key allocation or
cancellation
Coded Blank* - YES
Programming the
injection computer
Coded Coded Blank NO
IMPORTANT:
If a code is programmed into the UCH, the UCH is allocated to the vehicle. It is impossible to erase the code or
program in another one. The programmed code cannot be erased.
WARNING:
The keys submitted during this procedure will only work if:
they have already been coded on this vehicle,
or they are new (not coded).
Note:
If only the UCH is replaced, there is no operation to perform on the injection computer, as it retains the same
immobiliser code.
ACCESS – SAFETY
Fault finding – Configuration
To Next Page
Loading...
