Renault Duster 2007 - Tailgate Exterior Opening Control: Removal - Refitting

52A-10
NON-SIDE OPENING ELEMENT MECHANISMS
Tailgate exterior opening control: Removal - Refitting
52A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Remove the tailgate trim (see Tailgate trim: Re-
moval - Refitting) (73A, Non-side opening ele-
ments trim).
II - REMOVAL OPERATION
a Disconnect the connector (1) of the tailgate exterior
opening control.
a Unclip the linkage of the tailgate exterior opening
control at (2) using a screwdriver.
a Remove the bolts of the tailgate exterior opening
control (3) .
a Remove the tailgate exterior opening control.
REFITTING
REFITTING OPERATION
a Refit the tailgate exterior opening control.
a Torque tighten the bolts of the tailgate control (8
N.m).
a Pull the tailgate opening control linkage at (4) and
clip on the linkage at (5) .
a Connect the tailgate opening control connector.
a Carry out a function test.
FINAL OPERATION
a Proceed in the reverse order to removal.
Tightening torquesm
the bolts of the tailgate
control
8 N.m
145586
145787
145881