21A-1
MANUAL GEARBOX
Manual gearbox oils: Draining - Filling
JR5
21A
DRAINING
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
-the engine undertray bolts,
-the engine undertray.
a Fit the oil recovery tray under the gearbox.
a Remove the drain plug (1) .
a Allow the oil to flow into the oil recovery tray.
FILLING
a It is essential to replace the drain plug seal.
a Refit the drain plug fitted with a new seal.
a Torque tighten the drain plug (22 N.m).
a Remove the filler cap (2) .
a Fill the gearbox up to the level of the opening with oil
recommended by the manufacturer (see Manual
gearbox oil: Specifications) (Technical Note
6012A, 04, Lubricants).
a Refit the filler cap.
a Wipe any oil run-off with a cloth.
a Remove the oil recovery tray.
a Refit the engine undertray.
Tightening torquesm
drain plug 22 N.m
Type of
gearbox
Capacity
(litres)
JH1
2.8
JH3
JR5 2.5
18749
18749
92081