Renault Duster 2007 - Crankshaft Position Sensor: Removal - Refitting

13B-8
DIESEL INJECTION
Crankshaft position sensor: Removal - Refitting
K9K, and 796
13B
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
-the engine undertray bolts,
-the engine undertray.
II - REMOVAL OPERATION
a Disconnect the crankshaft position sensor connector
(1) from underneath the vehicle.
a From underneath the vehicle, remove:
-the crankshaft position sensor bolt (2) ,
-the crankshaft position sensor.
REFITTING
I - REFITTING OPERATION
a Refit the crankshaft position sensor.
a Torque tighten the crankshaft position and speed
sensor bolt (8 N.m).
a Connect the crankshaft position sensor connector.
II - FINAL OPERATION
a Refit the engine undertray.
Tightening torquesm
crankshaft position and
speed sensor bolt
8 N.m
24817