80D-22
AFTER REPAIR Carry out a road test, followed by a check with the diagnostic tool.
V1
MR-453-X79-80D000$100.mif
80D
UCH
Vdiag No.: 09
AC022
LEFT-HAND INDICATOR
NOTES
This command is used to activate the left-hand indicator.
There must be no present or stored faults.
Switch on the ignition.
Special note:
Use the Wiring Diagrams Technical Note for DUSTER.
Check the condition of the left-hand indicator light bulb. Replace the bulb if necessary (see MR 451 Mechanical,
80B, Headlights, Side indicator: Removal - Refitting).
Check the connection and condition of the connector of the UCH, component code 645, the rear left-hand light,
component code 173, the left-hand headlight, component code 227, and the left-hand repeater, component code
268.
If the connectors are faulty and if there is a repair procedure (see Technical Note 6015A (Renault) or Technical
Note 9804A (Dacia), Electrical wiring repair, Wiring: Precautions for repair), repair the connector, otherwise
replace the wiring.
Check for earth on the following connections:
• MB of component 227,
• MB of component 268,
• MG of component 173.
If the connections are faulty and if there is a repair procedure (see Technical Note 6015A (Renault) or Technical
Note 9804A (Dacia), Electrical wiring repair, Wiring: Precautions for repair), repair the wiring, otherwise
replace it.
UCH_V09_AC022
LIGHTING
Fault finding – Interpretation of commands
To Next Page
Loading...
