61A-26
HEATING
Heating resistors: Removal - Refitting
61A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Lock the airbag computer (see Fault finding - Re-
placement of components) (88C, Airbags and pre-
tensioners).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
-the driver's front airbag (see Driver's frontal air-
bag: Removal - Refitting) (88C, Airbags and pre-
tensioners),
-the steering wheel (see Steering wheel: Removal
- Refitting) (36A, Steering assembly),
-the steering column switch assembly (see Steer-
ing column switch assembly: Removal - Refit-
ting) (84A, Control - Signals),
-the instrument panel (see Instrument panel: Re-
moval - Refitting) (83A, Instrument panel)
-the storage compartment,
-the radio (see Radio: Removal - Refitting) (86A,
Radio),
-the dashboard (see Dashboard: Removal - Refit-
ting) (57A, Interior equipment).
a Remove:
- the heating resistor relay mounting bolt (1) ,
- the heating resistor relay mounting.
a Unclip:
- the wiring at (2) ,
- the ignition switch connector (3) from its mounting.
Tightening torquesm
lower bolts of the strut 21 N.m
upper nuts of the strut 21 N.m
LEFT-HAND DRIVE
24756
117093