Renault Duster 2007 - Vacuum Pump: Removal - Refitting

37A-14
MECHANICAL COMPONENT CONTROLS
Vacuum pump: Removal - Refitting
K9K
37A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Remove:
-the engine cover
-the air inlet duct.
a Gently move the air filter box aside to access the
vacuum pump.
II - REMOVAL OPERATION
a Disconnect the turbocharger control solenoid valve
pipe (1) from the vacuum pump.
a Disconnect the non-return valve (2) from the vacu-
um pump.
a Remove:
- the vacuum pump bolts (3) on the cylinder head,
- the vacuum pump.
REFITTING
I - REFITTING PREPARATION OPERATION
a Clean the vacuum pump bearing surface on the cyl-
inder head.
a parts always to be replaced: Brake servo vacu-
um pump seal.
II - REFITTING OPERATION
a Refit:
- the vacuum pump fitted with a new seal,
- the vacuum pump bolts.
a Torque tighten the vacuum pump bolts (21 N.m)
on the cylinder head.
a Connect the non-return valve to the vacuum pump.
a Connect the turbocharger control solenoid valve
pipe to the vacuum pump.
Tightening torquesm
the vacuum pump bolts 21 N.m
K9K, and 796
122813
24753
K9K, and 796