10A-42
ENGINE AND CYLINDER BLOCK ASSEMBLY
Oil pressure sensor: Removal - Refitting
K9K
10A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove the engine undertray.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Disconnect the oil pressure sensor connector.
a Remove the oil pressure sensor (2) using the.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Refit the oil pressure sensor.
a Torque tighten the oil pressure sensor (33 N.m).
a Connect the oil pressure sensor connector.
II - FINAL OPERATION
a Refit the engine undertray.
Tightening torquesm
oil pressure sensor 33 N.m
113894
To Next Page
Loading...
