36A-13
STEERING ASSEMBLY
Steering wheel: Removal - Refitting
36A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Apply the procedure for deactivating the safety sys-
tems. (see Airbag and pretensioners: Precau-
tions for the repair)
a
a Remove the driver's front airbag (see Driver's fron-
tal airbag: Removal - Refitting) .
a Set the wheels straight ahead.
a Disconnect the connectors.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Remove the steering wheel bolt (1) .
a Remove the steering wheel.
a
REFITTING
I - REFITTING PREPARATION OPERATION
a parts always to be replaced: Steering wheel bolt.
Tightening torquesm
new steering wheel bolt 44 N.m
IMPORTANT
Consult the safety and cleanliness advice and oper-
ation recommendations before carrying out any
repair (see 36A, Steering assembly, Steering:
Precautions for the repair, page 36A-2) .
WARNING
Incorrect wheel alignment may damage the
rotary switch.
122730
WARNING
To ensure that the electronic systems operate
correctly, do not damage the locking systems of
the connectors.
WARNING
To prevent damaging the rotary switch, do not
turn the mobile section of the rotary switch.
To Next Page
Loading...
