Renault Duster 2007 - Rear Brake Drum: Removal - Refitting

33A-7
REAR AXLE COMPONENTS
Rear brake drum: Removal - Refitting
33A
When replacing a brake drum, it is essential to replace
the drum on the opposite side as well.
When replacing a brake drum, it is essential to replace
the brake linings as well.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Release the parking brake.
a Remove the rear wheels (see 35A, Wheels and ty-
res, Wheel: Removal - Refitting, page 35A-1) .
II - REMOVAL OPERATION
a Remove the caps from the drums (1) .
a Remove:
- the rear brake drum nuts (2) ,
- the rear brake drums using the toolsand, if neces-
sary.
REFITTING
I - REFITTING PREPARATION OPERATION
a Check the internal diameter of the drum.
Equipment required
parts washer
Tightening torquesm
rear brake drum nut 280 N.m
IMPORTANT
Consult the safety and cleanliness advice and oper-
ation recommendations before carrying out any
repair (see 30A, General information, Brake cir-
cuit: Precautions for the repair, page 30A-2) .
IMPORTANT
The two brake drums should be the same diameter.
Regrinding one drum necessitates regrinding of the
opposite drum.
109709
109710