Renault Duster 2007 - Page 517

33A-11
REAR AXLE COMPONENTS
Rigid brake pipe: Removal - Refitting
33A
REFITTING
I - REFITTING PREPARATION OPERATION
a Always replace the rigid brake pipe mounting clips.
II - REFITTING OPERATION
a Refit the rear rigid brake pipes in their original posi-
tions.
a Clip the rear rigid brake pipes on the rear axle.
a Fit without tightening:
-the rigid brake pipe unions on the brake cylinders,
-the rigid brake pipe unions on the rear brake hoses.
a Torque tighten:
-the rigid brake pipe unions on the brake cylin-
ders (14 N.m),
-the rigid brake pipe unions on the rear brake
hoses (14 N.m).
III - FINAL OPERATION
a Remove the tool pedal press from the brake pedal
to limit the outflow of brake fluid.
a Bleed the brake circuit (see 30A, General informa-
tion, Braking circuit: Bleed, page 30A-4) .