Renault Duster 2007 - Page 103

10A-77
ENGINE AND CYLINDER BLOCK ASSEMBLY
Flywheel: Removal - Refitting
K9K
10A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Remove:
-the manual gearbox (see Manual gearbox: Re-
moval - Refitting) ,
-the clutch pressure plate (see Pressure plate -
Disc: Removal - Refitting) .
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Lock the flywheel with the(1).
a Remove the flywheel bolts.
a Remove:
-the flywheel,
-the.
REFITTING
I - REFITTING PREPARATION OPERATION
a Check the condition of the flywheel.
a parts always to be replaced: Flywheel bolts.
a Use SURFACE CLEANER (see Vehicle: Parts
and consumables for the repair) (04B, Consuma-
bles - Products) to clean and degrease:
- the crankshaft bearing face on the flywheel if re-
used,
- the flywheel pressure face on the crankshaft,
- the flywheel threading.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit the flywheel.
a Coat the new flywheel bolts with FRENETANCH
(see Vehicle: Parts and consumables for the re-
pair) (04B, Consumables - Products).
a Lock the flywheel using tool.
a Tighten to torque and in order the flywheel bolts
(55 N.m).
III - FINAL OPERATION
a Refit:
- the clutch pressure plate (see Pressure plate -
Disc: Removal - Refitting) ,
- the manual gearbox (see Manual gearbox: Re-
moval - Refitting) .
Tightening torquesm
flywheel bolts 55 N.m
109158 23326