80D-61
AFTER REPAIR Check the system operation.
V1
MR-453-X79-80D000$120.mif
LIGHTING
Fault finding – Fault Finding Chart
80D
UCH
Vdiag No.: 09
ALP 15 The timed courtesy light does not work
NOTES
Only address this customer complaint after a complete check with the diagnostic
tool.
There must be no present or stored faults.
Special note:
Use the Wiring Diagrams Technical Note for DUSTER.
Check by reading configuration LC047 timed courtesy light that the configuration corresponds to the vehicle
equipment.
Carry out the configuration using command SC008 UCH type if necessary.
Put the courtesy light in the AUTO position and run command AC145. If the courtesy light does not illuminate, refer
to the interpretation of this command.
If the fault is still present, contact the Techline.
UCH_V09_ALP15
To Next Page
Loading...
