82D-17
V1
MR-453-X79-82D000$060.mif
ACCESS – SAFETY
Fault finding – Programming
82D
UCH
Vdiag No.: 09
Enter the immobiliser code found in Code Management.
The tool displays Command in progress.
Insert the key to be allocated. It is important not to leave the previously allocated key in the ignition switch. Switch on
the ignition and then validate.
The tool displays Allocation in progress. Do not remove the key.
Switch off the ignition after allocation has finished.
Insert the next key to be allocated.
It is important not to leave the previously allocated key in the ignition switch. Switch on the ignition and then validate.
The tool displays Allocation in progress. Do not remove the key.
Switch off the ignition after allocation has finished.
The tool displays End of programming procedure.
IMPORTANT:
You now have 60 minutes to enter the code provided.
DO NOT DISCONNECT THE DIAGNOSTIC TOOL
To Next Page
Loading...
