88B-11
AFTER REPAIR
Carry out a new test using the diagnostic tool.
Clear the stored faults on all the computers connected to the network.
Deal with any other faults.
V1
MR-453-X79-88B000$040.mif
MULTIPLEXING
Fault finding – Interpretation of faults
88B
COMPUTERS NOT RECOGNISED
NOTES Check computer compatibility with the vehicle.
Check that the CLIP diagnostic tool update is recent enough to be able to deal with faults on the vehicle.
Switch to computer fault finding mode.
Attempt to establish dialogue with computers.
– No dialogue between computers and the diagnostic tool: see ALP 1 No dialogue with the computers
for computer(s) on which there is no dialogue with the diagnostic tool.
Check the connections to the computers and that there are no open circuits.
Repair if necessary.
– If there is communication with computers:
Make sure that the computer identification information is correct and matches the vehicle in fault finding.
Check that the following computer information is correct:
– Vdiag
–Program no. for the injection computers
If no faults or open or short circuits have been detected after these tests, contact Techline.
To Next Page
Loading...
