13B-6
DIESEL INJECTION
Diesel injection computer: Removal - Refitting
K9K
13B
REFITTING
I - REFITTING OPERATION
a Fit the injection computer on its mounting studs.
a Torque tighten the injection computer nuts (8
N.m).
a Connect the injection computer connectors.
II - FINAL OPERATION
a Refit the injection computer protector.
a Tighten to torque the injection computer protector
bolts (8 N.m).
a Clip on the positive terminal wiring.
a Refit the battery (see Battery: Removal - Refitting)
(80A, Battery).
a Respect the programming settings for the C2I (indi-
vidual injector correction) parameters and the en-
gine adaptives (see Fault finding - Replacement of
components) (13B, Diesel injection).
a Switch on the ignition and read the fault codes using
the Diagnostic tool.
a If necessary, repair the faults indicated.
a Clear the faults.
a Check that the vehicle is working properly.
To Next Page
Loading...
