13B-29
DIESEL INJECTION
Fuel temperature sensor: Removal - Refitting
K9K
13B
REFITTING
I - REFITTING PREPARATION OPERATION
a Lubricate the O-ring with lubricant from the applica-
tor supplied with the new part.
II - REFITTING OPERATION
a
a Remove the blanking plugs.
a Fit the fuel temperature sensor.
a Torque tighten the fuel temperature sensor (15
N.m).
a Connect the connector (3) of the fuel temperature
sensor.
III - FINAL OPERATION
a Connect:
-the injectors (2) of cylinders 3 and 4,
-the heater plugs (1) on cylinders 3 and 4.
a Start the engine.
a Check that there are no fuel leaks.
a Refit the engine cover.
Note:
Do not damage the O-ring when refitting.
To Next Page
Loading...
