Renault Duster 2007 - Page 325

19A-24
COOLING
Water chamber: Removal - Refitting
K9K, and 796
19A
II - REFITTING OPERATION
a Refit:
-a new water chamber seal in the water chamber
housing,
-the water chamber.
a Torque tighten the water chamber bolts (11 N.m).
a Connect:
-the cooling hoses to the water chamber,
-the coolant temperature sensor connector,
-the EGR assembly outlet pipe,
a Position the air duct between the intercooler and the
EGR assembly.
a Connect:
-the air duct on the EGR assembly,
-the union to the vacuum pump.
a Connect the EGR solenoid valve pipe to the vacuum
pump.
a Clip on:
-the breather pipe from the gearbox,
-the EGR solenoid valve pipes.
a Position the expansion bottle.
a Torque tighten the expansion bottle nuts (8 N.m).
III - FINAL OPERATION
a Refit the front bumper (see Front bumper: Remov-
al - Refitting) (55A, Exterior protection).
a Refit:
-the air filter unit (see 12A, Fuel mixture, Air filter
unit: Removal - Refitting, page 12A-6) ,
-the engine undertray,
-the engine cover.
a Fill and bleed the cooling system (see 19A, Cool-
ing, Cooling system: Draining - Refilling, page
19A-6) .