31A-6
FRONT AXLE COMPONENTS
Front brake hose: Removal - Refitting
31A
a Set the wheels straight ahead.
a Refit the brake hose at the calliper end.
a Torque tighten the brake hose (see 30A, General
information, Brake circuit: Tightening torque,
page 30A-6)
a Clip the brake hose cap on to the base of the shock
absorber, aligning the marks made using a perma-
nent marker.
a Refit:
-the brake hose on the rigid pipe union,
-the hose retaining fork.
a Torque tighten the brake hose union on the rigid
pipe union. (see 30A, General information, Brake
circuit: Tightening torque, page 30A-6)
II - FINAL OPERATION
a Refit the front wheel (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, page 35A-1) .
a Remove the pedal press from the brake pedal.
a Bleed the brake circuit (see 30A, General informa-
tion, Braking circuit: Bleed, page 30A-4) .
To Next Page
Loading...
