31A-12
FRONT AXLE COMPONENTS
Front brake calliper mounting: Removal - Refitting
31A
REFITTING
I - REFITTING PREPARATION OPERATION
a Clean using a wire brush and BRAKE CLEANER
(see Vehicle: Parts and consumables for the re-
pair) (04B, Consumables - Products):
-the front brake calliper mounting,
-the front brake calliper,
-the hub carrier.
a parts always to be replaced: Front brake calliper
mounting bolt
a Coat the calliper mounting bolts with HIGH
STRENGTH THREAD LOCK (see Vehicle: Parts
and consumables for the repair) (04B, Consum-
ables - Products) before fitting them.
a parts always to be replaced: Front brake calliper
guide pin bolt.
II - REFITTING OPERATION
a Refit:
-the front brake calliper mounting,
-the front brake calliper mounting bolts.
a Torque tighten the front brake calliper support
bolts (105 N.m).
III - FINAL OPERATION
a Refit the guide pin upper bolt.
a Torque tighten the guide pin upper bolt (34 N.m).
a Refit:
-the front brake pads (see 31A, Front axle compo-
nents, Front brake pads: Removal - Refitting,
page 31A-3) .
-the front wheel on the side concerned (see 35A,
Wheels and tyres, Wheel: Removal - Refitting,
page 35A-1)
IMPORTANT
To avoid any accident, bring the pistons, brake
pads and brake discs into contact by depressing
the brake pad several times.
To Next Page
Loading...
