31A-14
FRONT AXLE COMPONENTS
Front brake disc protector: Removal - Refitting
WHEEL DISC PROTECTOR
31A
REFITTING
I - REFITTING PREPARATION OPERATION
a Using a wire brush and SURFACE CLEANER (see
Vehicle: Parts and consumables for the repair)
(04B, Consumables - Products) clean the hub carri-
er.
II - REFITTING OPERATION
a Refit the brake disc protector.
a Torque tighten the bolts of the front brake disc
protector (7 N.m).
III - FINAL OPERATION
a Refit:
-the front brake disc (see 31A, Front axle compo-
nents, Front brake disc: Removal - Refitting,
page 31A-15) ,
-the « calliper mounting - brake calliper » assembly
(see 31A, Front axle components, Front brake
calliper mounting: Removal - Refitting, page
31A-11) ,
-the front brake pads (see 31A, Front axle compo-
nents, Front brake pads: Removal - Refitting,
page 31A-3) ,
-the front wheel (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, page 35A-1) .
IMPORTANT
To avoid any accident, bring the pistons, brake
pads and brake discs into contact by depressing
the brake pad several times.
To Next Page
Loading...
