35A-6
WHEELS AND TYRES
Wheel: Balancing
35A
a Enter the specific wheel parameters when starting
the wheel balancer.
a Start the wheel balancer and check the wheel bal-
ance, which should be 0 g on each plane of the
wheel.
a If this is not the case, remove the old wheel balanc-
ing weights and repeat the wheel balancing proce-
dure, checking that the wheel balance equals 0 on
each wheel plane.
IV - FINAL OPERATION
a Refit the wheel (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, page 35A-1) .
WARNING
To avoid detachment of the balance weights, use
only weights which correspond to the vehicle
wheel rims.
To Next Page
Loading...
