62C-2
V1
MR-453-X79-62C000$010.mif
62C
1. SCOPE OF THIS DOCUMENT
This document presents the fault finding procedure applicable to all computers with the following specifications:
2. PREREQUISITES FOR FAULT FINDING
Documentation type
Fault finding procedures (this document and the Technical Notes concerning the injection system fitted to
the vehicle, and the UCH):
– Assisted fault finding (integrated into the diagnostic tool), Dialogys.
Wiring Diagrams:
–Visu-Schéma (CD-ROM), paper.
Type of diagnostic tools
– CLIP + CAN sensor
Special tooling required
3. REMINDERS
Procedure
To run fault finding on the vehicle computers, proceed as follows:
–turn the ignition key to APC,
– connect the diagnostic tool and perform the required operations,
To cut off the + after ignition feed, proceed as follows:
–disconnect the diagnostic tool,
–turn the ignition key to OFF,
– switch off the ignition.
Vehicle(s): DUSTER
Function concerned: Climate Control
Special tooling required
Multimeter
Elé. 1681 Universal bornier
CLIMATE CONTROL
Fault finding – Introduction
To Next Page
Loading...
