RFL Electronics RFL 9300 - Table 6-3. RFL 9300 Module, General Information

RFL 9300 RFL Electronics Inc.
January 30, 2002 6-5 (973) 334-3100
Table 6-3. RFL 9300 Module, General Information
Module
Description
Model
Number
Assembly
Number
Module
Position Numbers
(See Figure 6-3)
Module location Additional
Information
Display Module 93B DISPLAY 106320 (HORIZ)
106320-1 (VERT)
10 Front Section 9
Supervisor Controller
Module
93B SV 106300-1 5 Front Section 10
Auxiliary Current Trans-
former I/O Module
93B ACT I/O 106345-1, -5 13 - 16 Rear Section 11
Phase
Controller Module
93B PC 106370 6 thru 9 Front Section 12
Communications Con-
troller Module
93B CC
(1)
106365 3 Front Section 13
BLANK 4 Front
93B CC
(1)
106365 4 Front
Modem
Module
93B MO 106355 1 - 2 Front Section 14
Line Coupler
I/O Module
93 LC I/O 103835 18 - 19 Rear Section 15
Direct Digital Interface
I/O Module
93 DD I/O 103830-1 18 - 19 Rear Section 16
Single Width Fiber Optic
Transceiver Module
(2)
93B FT/FR 106360 1 - 2 Front Section 17
Single Width Fiber Optic
I/O Modules
93 FT/FR I/O 8M
93 FT/FR I/O 13M
93 FT/FR I/O 13S
93 FT/FR I/O 13SL
93 FT/FR I/O 15SL
105850
105855
105860
105865
105870
18 - 19 Rear Section 18
Power Supply
Module
9300 PS 48/125 DC 106715-1 11 Front Section 19
Relay I/O
Module
93B RELAY I/O 106385 12 Rear Section 20
Alarm I/O Module 93 ALARM I/O
93 ALARM I/O (24V)
104775-5
104775-6
17 Rear Section 21
Short Haul Fiber
Interface Module
93 SHFI 106340 18-19 Rear Section 22
Fiber Service Unit FSU 9V
FSU 48V
FSU 129V
105075-1
105075-2
105075-3
NA External
To Chassis
Section 22
G.703 Interface I/O
Module
93 G.703 106730 18-19 Rear Section 23
Single Pole Chassis 9300 SINGLE POLE
TRIP
106700 NA Below 9300 Chassis Section 24
Chassis Assembly 9300B 105885 NA NA Section 25
Mother Board 93B INTER 105895 NA Mounted inside
Chassis Assembly
Section 25
RS-232 Front Panel
Inter
RS-232 106775 NA Behind Front Panel Section 25
250V Power Supply
Expansion Chassis
POWER CONV I/O
250VDC
105875 20 Mounted below
Chassis Assembly
Section 26
1. Two-terminal installations use one 93B CC installed at each site in module position #3 with module position #4 blank. Three-terminal instal-
lations use two 93B CCs at each site, one installed in module position #3 and one installed in module position #4.
2. In a two-terminal system the transceiver in position 1 corresponds to the 93B CC in position 3. In a three-terminal system the trans-
ceiver in position 2 corresponds to the 93B CC module in position 4. In a two-terminal system with hot-standby, transceivers in posi-
tions 1 and 2 correspond to the 93B CC in position 3.